Hive 2 - Logic Pro X - Loses MPE settings status on each re-load

[playingGuitar]

Hi there,
I'm new to the forum, new to MPE and new to Hive2, so please forgive me if what I'm saying doesn't make much sense.

I am using Hive2 with Logic Pro X and I have an Osmose as controller. Following the instructions to let MPE work, I switch on the MPE settings on the UI (bottom left side of the UI - on the left of the "Pitch" controller") and then set the Control A to CC74.

It actually works.
But... every time I close Logic or I reload a project, the MPE settings are gone and I need to setup again in all the tracks the MPE values. If I have 25 tracks...

I'd appreciate a lot if someone can give me an hint about how to make the MPE setting stick or at least it can be saved somewhere within the track information.

Thanks,
Alex