Just want to figure out how to use the note event pad to momentarily switch between two different audio signals. My brain isn't working today. The two audio signals are a sample player which is playing a reference track, and the master bus.
I've tried using the 2 to 1 audio balancer but got stuck trying to make the balancer go back to zero again.
Note Event Pad - momentarily switch from one sound to another
-
- KVRist
- 206 posts since 9 Feb, 2016
Aka Midland Synthetics
-
- KVRist
- Topic Starter
- 206 posts since 9 Feb, 2016
I just did it using the midi trigger pad and a controller to modulation convertor 
You do not have the required permissions to view the files attached to this post.
Aka Midland Synthetics
-
- KVRAF
- 13850 posts since 24 Jun, 2008 from Europe
Crossed posts, an alternative way:
See attached MUX preset:
It uses an Audio Dispatcher with 2 ins and 1 out.
C4 note on will select the first input.
C4 note off will generate a C#4 note on-off using the Note On Upon Note Off Generator and that way will select the second audio input of the Audio Dispatcher.
See attached MUX preset:
It uses an Audio Dispatcher with 2 ins and 1 out.
C4 note on will select the first input.
C4 note off will generate a C#4 note on-off using the Note On Upon Note Off Generator and that way will select the second audio input of the Audio Dispatcher.
You do not have the required permissions to view the files attached to this post.
-
- KVRist
- Topic Starter
- 206 posts since 9 Feb, 2016
I now see the logic of the note on upon note off module
Thanks again, Jo.
Thanks again, Jo.
Aka Midland Synthetics
-
- KVRAF
- 13850 posts since 24 Jun, 2008 from Europe
That module is also nice to create special effects in synth patches, eg. some special new sound upon start of release...