I have no explanation for this behaviour. A simple Midi CC rectangle modulation, is not a rectangle anymore, once it arrives in the Poly Grid device. It looks and sounds like, as if a slew limiter has been placed in the signal path. Can anyone explain this?
[solved] The Grid: Midi CC transmisson is not accurate
-
- KVRian
- 913 posts since 26 Jul, 2018 from Germany
You do not have the required permissions to view the files attached to this post.
Last edited by Rastkovic on Mon Jul 20, 2026 9:23 am, edited 2 times in total.
-
- KVRAF
- 8088 posts since 9 Jan, 2003 from Saint Louis MO
There's a simple explanation: a slew limiter has been placed in the signal path.Rastkovic wrote: Fri Jul 17, 2026 9:45 am It looks and sounds like, as if a slew limiter has been placed in the signal path. Can anyone explain this?
I wish it was optional... it makes a little sense for some types of CC but definitely not when you use CC for automation. Meanwhile, I wish pressure was slewed and it's not (or at least not enough).
-
- KVRian
- Topic Starter
- 913 posts since 26 Jul, 2018 from Germany
That would be weird, because this effect can easily be added by using an Average module.
Maybe a relic from the pre-Note-Grid era. However, I sent a request to the Bitwig Team on Friday.
You do not have the required permissions to view the files attached to this post.
-
- KVRian
- Topic Starter
- 913 posts since 26 Jul, 2018 from Germany
The Bitwig support answered. At least in this case, it can be easily turned off, by disabling the "Smoothing" option in the Poly Grid's "CC In" module. That was simple, I wasn't aware of that.
You do not have the required permissions to view the files attached to this post.
-
- KVRAF
- 8088 posts since 9 Jan, 2003 from Saint Louis MO