Bounce with tails

[olaims]

Hello,

There is an option to make a bounce recording also the tails of the reverbs/delays and so on?

When I export the Stems it works, but I want to do it direct on Bitwig if there is a possibility.

Thanks!

[Cyoon]

you could put the track in a group, draw a midi clip over the whole area, and bounce that in place. Alternatively do this on the master track.

[olaims]

you could put the track in a group, draw a midi clip over the whole area, and bounce that in place. Alternatively do this on the master track.

midi clip inside the group or outside the group?

[Cyoon]

oh, doesn't work on the group, you need to use the master.

Solo your track, draw a clip on the master track for the duration of your reverb tail. Then bounce that master clip in place. There you got the sample.

[olaims]

oh, doesn't work on the group, you need to use the master.

Ok

Thanks for your reply!

[Cyoon]

various other ways are also possible, sending to an fx track pre fader or setting the output to a new audio track and record there, or use an audio receiver on another audio track. But i think the master track solution is the fastest.

[Cyoon]

missed the most obvious one lol. Just create a clip on your reverb tail track, long enough to cover it. Then bounce that in place

[Caine123]

this is so clunky, i wonder why it doesnt do it like e.g. FL Studio where you can set EXPORT WITH TAIL....