New to Tracktion, I didn't find my question among the NB-questions...sorry...
What can "Patch Bay Filter" do? When I insert it on a track I get two inputs (L+R) and two outputs (L+R) and I can route freely between them. All fine but is that all? Is there no way to for example route the signal to another track or another plugin or something like that?
What can patch bay filter do?
-
- KVRist
- 46 posts since 24 Jan, 2005
-
- KVRAF
- 1714 posts since 14 Mar, 2003 from Israel
Patch Bay allows you to do couple of handy rewiring tricks (like reversing stereo, stereo>mono, mono<stereo.). Putting after a multi-out filter will allow you to access all the filter's output.
Rack Filters give you much more routing power (the Patchbay is pre-Racks), but the Patchbay Filter can still be used as an easier solution or to avoid some Rack Filters related hazards.
(If you are new to Tracktion, you should read about Rack Filters).
Rack Filters give you much more routing power (the Patchbay is pre-Racks), but the Patchbay Filter can still be used as an easier solution or to avoid some Rack Filters related hazards.
(If you are new to Tracktion, you should read about Rack Filters).
CubaseStudio4 µTonic/Rapture Nitro/GS-201/Ohmicide/TBK 1&3
-
- KVRist
- Topic Starter
- 46 posts since 24 Jan, 2005
Yes, but where? I don't find any details about it in any of the help pages nor in the forums. Am I missing something, it seems like I can't find any details about filters and such that are included in Tracktion. Am I supposed to figure it all out by myself...?spacefox wrote: (If you are new to Tracktion, you should read about Rack Filters).
-
- KVRist
- 146 posts since 14 May, 2004 from Orygone
-
- KVRist
- Topic Starter
- 46 posts since 24 Jan, 2005
Ah... thats the missing link 
Thanks!
Thanks!