I am using the M-Audio Firewire Solo and its analogue outputs sound terrible and are very low volume. The inputs seem fine, so I was wanting to use the "firewire" for input and "built in" for the output, but the Wave Device setting only lets you have 1 or the other, not both. Any help would be great?
Mac Mini 1.42 80GB SD
Keystation Pro
Audio device settings problem
-
- KVRAF
- 10815 posts since 26 Nov, 2004 from UK
Sorry its one sound divice at a time 
Beno has stated T2 will be the same
But with your sound card your using for your input you should be able to get a good out put??
how low is your latincey?? Try 10ms if its over that allready then post more info! there are some clever cats on this forum that im shore can help you
Subject
Beno has stated T2 will be the same
But with your sound card your using for your input you should be able to get a good out put??
how low is your latincey?? Try 10ms if its over that allready then post more info! there are some clever cats on this forum that im shore can help you
Subject