Tracktion Software

jplanet · Post by **jplanet** » Tue Oct 04, 2005 3:59 pm

the new Rob Papen Blue, and ConreteFX's Kubik make no sound in T2 (except when first installed, then after that nothing).

I haven't been able to find anyone else to test this out, though...

SuitcaseOfLizards · Post by **SuitcaseOfLizards** » Tue Oct 04, 2005 4:07 pm

I have Kubik 2.16 and T2 2.0.1.13 here on WinXP, loaded up Kubik, played, saved edit, exited, fired up T2 again and reloaded the edit - everything worked fine.

I assume you've checked to make sure MIDI is coming in and have switched end-to-end on, so about all I can say is try toggling end-to-end off/on and see if things suddenly start working.

I've seen the odd issue with Vectrik though, so maybe it's not Tracktions fault...

jplanet · Post by **jplanet** » Tue Oct 04, 2005 4:28 pm

I figured since both Blue and Kubik are ConcreteFX products, it must have something to do with common code used in them...

Tried toggling e to e, but no joy. MIDI's definitely coming in, any other vsti that I substitute works fine.

i wonder if it is a conflict with any other vsti's?

ModuLR · Post by **ModuLR** » Tue Oct 04, 2005 4:38 pm

Blue is a Rob Papen synth...

SuitcaseOfLizards · Post by **SuitcaseOfLizards** » Tue Oct 04, 2005 4:40 pm

Hmm.. could be. I did notice that once I wiped out most of my VSTi and reinstalled only a few, things did get better..

I also run energyXT and I've had Vectrik crash it.. I suspect you're right, there's something in common code that causes problems.

Have you posted in the ConcreteFX forum yet?

SuitcaseOfLizards · Post by **SuitcaseOfLizards** » Tue Oct 04, 2005 4:47 pm

ModuLR wrote:Blue is a Rob Papen synth...

Erm...

http://www.kvraudio.com/forum/viewtopic ... 14&start=0

ModuLR · Post by **ModuLR** » Tue Oct 04, 2005 6:05 pm

please pass me the idiot crown!

besides what do I know.. I just bought FabFilter One... single oscilator is about all my brain can handle.

djsubject · Post by **djsubject** » Tue Oct 04, 2005 6:09 pm

ModuLR wrote:. single oscilator is about all my brain can handle.

but thats not verry modula

SuitcaseOfLizards · Post by **SuitcaseOfLizards** » Tue Oct 04, 2005 6:09 pm

lol no worries mate! If I hadn't been tracking CoFX stuff all the time I'd not know either!!!!

Brain? What's a brain? I don't have one of those, should I get one off eBay?

djsubject · Post by **djsubject** » Tue Oct 04, 2005 6:17 pm

PS, if you havent tryed the blue demo i think you should!

its lovley

rob is a dapper when it comes to vsti's

Subz

rpc9943 · Post by **rpc9943** » Tue Oct 04, 2005 6:38 pm

uhmm im a dedicated t2 user and i use kubik all the time. so its not me its you.

RoNC

SuitcaseOfLizards · Post by **SuitcaseOfLizards** » Tue Oct 04, 2005 6:52 pm

rpc9943 wrote:uhmm im a dedicated t2 user and i use kubik all the time. so its not me its you.

RoNC

No, it's you.

rpc9943 · Post by **rpc9943** » Tue Oct 04, 2005 8:05 pm

what does that make you , loach? dont you even start flaming here bucko

RONC

jplanet · Post by **jplanet** » Tue Oct 04, 2005 10:00 pm

woolyloach wrote:
Have you posted in the ConcreteFX forum yet?

Yup, I gave it a shot, nobody reports the same problem...So I posted here in case it was a T2 issue...

SuitcaseOfLizards · Post by **SuitcaseOfLizards** » Tue Oct 04, 2005 10:06 pm

rpc9943 wrote:what does that make you , loach? dont you even start flaming here bucko

RONC

Is this where I pretend to be afraid of you? Nobody else is, why should I be?

Kubik is unstable on some systems, you should go read the bug thread. You're just one of the lucky few that haven't had issues with it.

Tracktion Software

KVR Audio

BR: Blue and Kubik have no sound in T2