When I have end-to-end enabled Tracktion outputs the sound I play with a delay, which gets mixed with the original sound at my mixer. This sounds a bit weird, especially when doing vibratos.
If I turn off end-to-end the problem goes away, so that would solve it.
However, when I'm recording, the problem occurs even if I have end-to-end disabled. And it doesn't help to mute the track either.
Is there some way to turn of end-to-end while recording?
/Jörgen
PS I'm running Tracktion 1.5.something.
End-to-end while recording?
-
- KVRian
- 544 posts since 24 Jan, 2004 from Sweden
-
- KVRAF
- 6490 posts since 14 Jun, 2004 from Rochester, NY
-
- KVRian
- Topic Starter
- 544 posts since 24 Jan, 2004 from Sweden
I have a Tascam MM-1 mixer, where I route two of the sends to the audio inputs of the computer.rpc9943 wrote:what kind of audio setup are you using?
RonC
This way, I can record any instrument and at the same time listen to any combination of instuments without repatching.
The outputs from the computer are routed to a stereo input on the mixer. I suppose I could mute that input, but then I would not hear the metronome (or other tracks) while recording.
/Jörgen
-
- KVRAF
- 6740 posts since 25 Mar, 2002 from sheffield, england
Select the input and turn off the other end to end button. (there's one for each input as well as the one by the transport controls)Stuttaton wrote:
Is there some way to turn of end-to-end while recording?
-
- KVRian
- Topic Starter
- 544 posts since 24 Jan, 2004 from Sweden
Thanks for the tip! That solved the problem nicely.
/Jörgen
/Jörgen