Hello all,
I am busy trying to get all my stuff installed on the Receptor and am having some issues around Wusikstation 3. I am aware of the need to convert its native format into FXP patches, but having now done that i cannot figure out where to place these patche in the recpetor so that it can "see" them.
As it stands I can load the PRST from inside W3 but crash about every second one. Not a great solution. So if anyone knows how to bring these converted fxp's into receptor that would be a huge help.
Thanks,
Eric
Wusikstation 3 on Receptor
-
- KVRer
- 2 posts since 24 Feb, 2006
-
- KVRist
- 90 posts since 6 Aug, 2004 from United States
You need to put all the converted files into the Installer folder. Just drop them in the folder and install them from Setup screen on the remote or the front panel. IT will take care of everything for you.
The main problem is the cataloging of the files. I had to rename them somewhat and move them around into new folders before installing. The first time I installed them, I ended up with 6ish banks of WSEQ, etc, with no "folder name" to go by.
I ended up merging the folders with each patch into the master folder (ToTc for example) and renaming the patches with a prefix like LED_ or WSEQ_ etc.
The main problem is the cataloging of the files. I had to rename them somewhat and move them around into new folders before installing. The first time I installed them, I ended up with 6ish banks of WSEQ, etc, with no "folder name" to go by.
I ended up merging the folders with each patch into the master folder (ToTc for example) and renaming the patches with a prefix like LED_ or WSEQ_ etc.