Muse Research

rudy g · Post by **rudy g** » Sun Apr 08, 2007 10:43 am

When Receptor loads one of my song patches that is then played via midi, the z3ta+ patches load OK but often fail to play, but other synth patches play fine. After some time, Z3ta+ will 'suddenly' start to play OK. This problem only happens with this synth.

I a using z3ta+ v1.4 purchased via Plugorama and the latest Receptor s/w. I have reloaded Z3ta+ but problem remains. Any ideas what the problem may be?

rudy g · Post by **rudy g** » Mon Apr 30, 2007 11:17 pm

Update...just loaded v1.6 Receptor software and these problems with stalled synths [including z3ta+] now solved...excellent!

tjodoin · Post by **tjodoin** » Tue May 01, 2007 1:06 pm

Where'd you get v1.6? I only see v1.5 on Plugorama.

rudy g · Post by **rudy g** » Tue May 01, 2007 3:18 pm

I received it via a message from Muse, after submitting my problem to them and receiving a support ticket. Not sure if it is for general release yet...but I understand it is imminent.

tjodoin · Post by **tjodoin** » Tue May 01, 2007 4:00 pm

Nice. Does it also now support the new NI service center?

rudy g · Post by **rudy g** » Wed May 02, 2007 7:36 pm

Not sure...I just received an update with no documentation. Moreover, I don't know what NI Service Centre is!

tjodoin · Post by **tjodoin** » Wed May 02, 2007 8:33 pm

Sorry, it's Native Instruments copy protection. Apprarently the 1.6 update is supposed to resolve the issues that have been preventing the most recent versions of Kontakt, Komplete4, etc. from being installed.

Muse Research

KVR Audio

z3ta+ not playing properly on Receptor