When I go to install the dat files from my mac to receptor the install program says to make sure the drive is formated for OSX which I know is windows formatted on the receptor. How do I get around this.
PT
MacPRo Intel, Receptor rev C
Mac install of Atmosphere
-
- KVRian
- 691 posts since 13 May, 2004 from Silicon Valley
Hi PTop,
I'm not sure that I have seen this before, and it could very well be that behavior on Intel Mac's is different from G4/G5s. Typically, the .dat files are platform independent, and shouldn't matter.
Are you using Muse's Atmosphere 'prep' installer to install Atmosphere (first), and then copying the .dat files (second)?
Regards,
Kevin L
I'm not sure that I have seen this before, and it could very well be that behavior on Intel Mac's is different from G4/G5s. Typically, the .dat files are platform independent, and shouldn't matter.
Are you using Muse's Atmosphere 'prep' installer to install Atmosphere (first), and then copying the .dat files (second)?
Regards,
Kevin L
-
- KVRist
- 69 posts since 9 Jan, 2006
I think he's trying to install directly TO the Receptor. Try to install it onto your Mac first and after that copy the .dat files from your Mac's HD to the Receptor HD.
--
Olle Gustafsson
--
Olle Gustafsson
-
- KVRer
- Topic Starter
- 4 posts since 19 Jun, 2007 from Lake View Terrace, CA
Yeah I was trying to load from the installer right to Receptor instead of installing to my desktop and then dragging it over. When dragging it over got error message that there's not enough space left. I then remembered that last week I had to move a file to Apple and it was 3.7GBs so I had to use samba to do it since appletalk can only move a file up to 2GBs. So that was a no-brainer. I also downloaded the windows dll from Spectrasonics and loaded that to Receptor. Everything worked for Trilogy but Atmosphere still isn't loading right and I'm doing everything the same that I did for Trilogy.
Don't figure,
PT
Don't figure,
PT