Free running oscillator question

[michkhol]

I couldn't find it in the Zebra2 manual, so here is the question:

I'm experimenting with the oscillator phase sync and I noticed that I can get the "free running osc" effect (where each keypress gives different tone for two oscillators) only if I set one oscillator's phase reset to "On" and the other to "Off". Setting both to "On" or "Off" behaves like both oscillators are phase-synced. For the first case apparently the phase of both oscillators is drifting but in the same way. Is it the intended behavior, can I rely on it in the future?

Or some day a "true" free-running mode (phase drifting differently for each oscillator) will be implemented?

[Urs]

Phase drifting differently can be achieved by detune, or by randomly modulating phase...

There are no plans to change anything. Whenever changes occurr, they are optional and the old behaviour will be default...

[michkhol]

Thanks!

Actually I just found out that phases begin to drift differently after I set the Phase knob to any value and back to zero on one of the oscillators. Interesting effect...