I own NI's Komplete Sound, Synthetic Drums and some other sound libs. Anyone know how to toss them onto a receptor? ..am wondering if it's as easy as just dropping them into some subfolder..
Thanks in advance
Installing sound libraries (ie. Komplete Sound)
-
- KVRer
- 2 posts since 28 Dec, 2004
-
- KVRer
- Topic Starter
- 2 posts since 28 Dec, 2004
I've made some progress on this.. I installed Komplete Sound (which include synthetic drums 1& 2, and several other sound libs) on my powerbook. It does not require NI Service Center and uses one SN for the entire collection. After installing it there, I copied the Kit folders over to the C:\Samples folder on the receptor. Upon loading a kit into Battery 3 (my receptor has komplete 4 installed), I get a pop up "Audio Setup" window (which has 3 tabs: Soundcard, Routing, Midi) indicating that I need to select a sound card. There is nothing available in the pulldown menu for it, and if I click OK, I get this message: "You have to set at least a valid audio interface. Try again? (choosing no will quit Battery 3)". The only choice I have is to click NO, and the window goes away, but Battery 3 continues to run.. and the kit seems to work fine.
I've asked plugorama support for advice on whether this install may be problematic or whether there's a better way to do it. Their support has mainly said that only Muse can install it upon purchase.. which isn't exactly helpful at this point.
I've asked plugorama support for advice on whether this install may be problematic or whether there's a better way to do it. Their support has mainly said that only Muse can install it upon purchase.. which isn't exactly helpful at this point.