Zebra CM / microTERA Issues

[ganym3d]

Yo Urs!

After playing a little bit with microTERA from
VirSyn, i discovered some bad news: If I open the
microTERA (in Cubase SE3 on Win XP / SP2), i can't
open the Zebra CM PlugIn anymore...

I try to open it in the Synth-Rack of Cubase, but
nothing happens. This ONLY happens if I opened
microTERA before...

Other synths (e.g z3ta+) are working fine. Any
ideas?

Striped Greetings from Berlin

ganym3d

[Urs]

Any ideas?

Hmmm, you lost me here... I don't know microTera...

Does this happen in all hosts?

Sunny greetings back aus Charlottenburg,

Urs

[ganym3d]

Hi Urs!

microTERA is a special edition of VirSyn's bigger TERA 2.0

It was distributed long time ago (in 2003 i think) on the german KEYS-Magazine.

I only tested this in Cubase (which is my only sequencer on PC)...

Don't know if this happens in other hosts...

Again, greetings from the middle of Berlin

ganym3d

[zerocrossing]

I have Zebra 2 and MiniTera (or it's kick ass sister Poseidon) running together... perhaps you just need to buy full versions of your instruments. You do actually get what you pay for.

Hi Urs!

microTERA is a special edition of VirSyn's bigger TERA 2.0

It was distributed long time ago (in 2003 i think) on the german KEYS-Magazine.

I only tested this in Cubase (which is my only sequencer on PC)...

Don't know if this happens in other hosts...

Again, greetings from the middle of Berlin

ganym3d

[ganym3d]

...problem solved. Bin-ned microTERA (since this is a Mag-Version, it's without support). And because i can't imagine to start a new project without my striped beauty, the decision was simple...

ganym3d