As I understand it triplets are faster than standard time, yet in Zebra it runs slower i.e. 1/8t is slower than 1/8. What's going on here, I'm starting to doubt my own (admittedly) rudimentary knowledge...It's the same in Filterscape but the other synths I own behave as I would expect.
Mart.
tempo sync in Zebra
-
- u-he
- 30215 posts since 8 Aug, 2002 from Berlin
My bad. I got them mixed up by factor 2. WIll eventually correct their naming (but keep the values for compatibility) 
-
- Banned
- 6129 posts since 9 Oct, 2007 from an inharmonious society
I usually just increase the LFO's rate to 110 or 112 instead of the default 100 to bring the timing up to where I need it if using dot or trip timing.
I'm using ZebraCM but it's the same in Zebra2.
I'm using ZebraCM but it's the same in Zebra2.