kontakt multi outputs on adat outs

[nl3]

Hi all,
is it possible to assign a single Receptor mixer channel (eg. ch 1), meaning of a single kontakt 2.2 instantiation on ONE Receptor channel only), to one or more or all 8 adat outputs selected, while deciding to assign every single audio signal path inside the mixer section of the Native Instruments plugin?
I need to have such a surround output (on Receptor's adat outs thru my Behringer ada8000 adat-to-analog interface) from one single Receptor channel instantiation.
In a few words, is it possible to assign a signal of a plugin like Kontakt to out on one or more adat output in a single Receptor mixer channel having all adat outputs selected?
Please suggest me a solution, if it exists.
Thanks,
PGi

[johnrule]

I think you have to load Kontakt on channel 1, and then you will have the outputs available for assigning to other channels. Then, on each channel, you press the 'Output' button to assign the path (adat, spdif, etc.).


JR

[nl3]

I think you have to load Kontakt on channel 1, and then you will have the outputs available for assigning to other channels. Then, on each channel, you press the 'Output' button to assign the path (adat, spdif, etc.).


JR

Hi,
i have found a solution, as follows
create a Surround out on the Output section on Kontakt, this brings the signal on a path ending at 6 plugin's outputs. Anyway, any Receptor channel is hardwired to be assigned to ONE ONLY out but the master out, so i have to instantiate one (a couple each) "feedback output signal" in two other Receptor mixer channel, and assign these Receptor's channels to the adats or other separate outs.
It's a tricky solution and works, but loads the cpu a little more, and it's a good way if i don't need so many fx in the paths.
Thanks,
PGi

[htamak]

Hi guys, i just got myself the Muse Komplete Receptor, which i'm using with a g5 mac, the Apogee Ensemble & Nuendo4. Since i'm new to this, my questions might seem dumb to u guys, so apologies ! Here goes,

1) I'm only being able to get one stereo output from the muse through unwire( thru ethernet)onto my Nuendo 4 mixer..is it possible to get more outputs into the nuendo mixer, through the ethernet, or do i have to connect the adat outputs ?

2) In Adat mode, will midi messages still go through the ethernet port or would i have to connect the midi ports also ?

thanks in advance guys.

[MortimerBenz]

Hey guys,

You should check this link out. Found in the knowledge base,,hope it helps,

http://www.plugorama.com/customer/kb.php?kbid=08062702

Mortimer

[htamak]

hey thanks Mortimer, i figured out the Adat connections soon enough and your link helped confirm the procedure. Now i can sequence in peace !

Ok so, basically, i cannot get more than a stereo output into my software sequencer thru uniwire, can i ? i'm just curious, cause i have'nt seen any thread mentioning this anywhere !

[Nonplus]

once you add a multiout instrument (on any channel), it's additional outputs will appear as virtual inputs at the end of the plugin list in any/all other instrument slots.

if you're using Kontakt 3, it will probably crash when you open it up and try to assign another output. thanks muse. however, it (gasp) worked for me with bat3 & miroslav.