u-he

present · Post by **present** » Tue Oct 27, 2009 12:29 pm

Is it possible in Zebra to modify an LFO's rate with both an envelope and the mod wheel?

Thanks!

Urs · Post by **Urs** » Tue Oct 27, 2009 12:37 pm

Yes, but you have to use the ModMatrix. That is, you'd use the Envelope directly in the LFO while adding ModWheel via the ModMatrix.

Cheers,

Urs

present · Post by **present** » Tue Oct 27, 2009 1:34 pm

aha, ok I'll look into it! thanks

djsubject · Post by **djsubject** » Tue Oct 27, 2009 2:14 pm

i used to think Zebra modulation was quite limited intill i found the mod matrix

you can do allot of mapping before you even touch there

hopeing CC numbers can become mod sources at some point, my BCR2000 is feeling slightly over qualified

Subz

bmrzycki · Post by **bmrzycki** » Tue Oct 27, 2009 4:22 pm

I just noticed we're unable to use ModMixers and ModMappers as modulation sources for LFO's directly. Is this intentional?

It's not so much of an issue anymore especially since we now have 12 modmatrix slots. I just found that curious.

Urs · Post by **Urs** » Tue Oct 27, 2009 4:27 pm

bmrzycki wrote:I just noticed we're unable to use ModMixers and ModMappers as modulation sources for LFO's directly. Is this intentional?

It's not so much of an issue anymore especially since we now have 12 modmatrix slots. I just found that curious.

The modules are evaluated one after the other, so at the point when the LFOs are processed, none of the ModMixers/ModMappers are. Hence the fast & instantaneous "direct" modulations slots don't work from back to front, but the ModMatrix works, with a few samples delay though.

u-he

KVR Audio

Zebra LFO parameters