u-he

Reflected · Post by **Reflected** » Thu Dec 17, 2009 1:01 am

It seems that the 'pan' and the 'ratio' parameters are not automatable

can you please make all the parameters automation-able?

thank you so much.

bmrzycki · Post by **bmrzycki** » Thu Dec 17, 2009 1:23 am

You can assign these knobs to one of the 8 X/Y axes. From there you can automate this axis from your host.

Reflected · Post by **Reflected** » Thu Dec 17, 2009 1:52 am

bmrzycki wrote:You can assign these knobs to one of the 8 X/Y axes. From there you can automate this axis from your host.

fair enough.
I wish that I could link it to the LFOs as well.

thanks for the input m8

bmrzycki · Post by **bmrzycki** » Thu Dec 17, 2009 2:46 am

I'm not exactly sure how you're trying to modulate the sound, but odds are you can do it. You should read the manual's sections on direct modulation and the modmatrix.

Modulation Mapping:
http://www.u-he.com/zebra/manual/?page_id=13

The Z2 LFO:
http://www.u-he.com/zebra/manual/?page_id=15

The modMatrix has moved, it's now a tab at the bottom of the synth. Otherwise these same instructions apply:
http://www.u-he.com/zebra/manual/?page_id=28

pdxindy · Post by **pdxindy** » Thu Dec 17, 2009 5:35 am

Reflected wrote: I wish that I could link it to the LFOs as well.

You can!

Reflected · Post by **Reflected** » Thu Dec 17, 2009 8:58 am

pdxindy · Post by **pdxindy** » Thu Dec 17, 2009 10:06 am

Reflected wrote:how?

Go to the mod matrix, select target as say Delay1, Ratio3...for the mod, select LFO (1,2,3,4)

You can pretty much modulate anything in Zebra. If you want to automate Ratio or Pan, right click on the Ratio control and select assign to... X or Y 1,2,3. Then the XY control can be modulated. The XY's are great to control multiple parameters at once.

Reflected · Post by **Reflected** » Thu Dec 17, 2009 10:10 am

pdxindy wrote:
Reflected wrote:how?
Go to the mod matrix, select target as say Delay1, Ratio3...for the mod, select LFO (1,2,3,4)

You can pretty much modulate anything in Zebra. If you want to automate Ratio or Pan, right click on the Ratio control and select assign to... X or Y 1,2,3. Then the XY control can be modulated. The XY's are great to control multiple parameters at once.

Woooo! amazing.

Thank you so much for the quick reply my friend

u-he

KVR Audio

No automation for delay parameters? (Zebrify)