Save Arpeggiator Configuration

[jimstrider]

Howdy:

Searched the Zebra2 interface, searched the Zebra2 manual, searched this forum,... no luck.

Can one of the local experts tell me how to save, or at least copy and paste, arpeggiator settings in Zebra2? I have created a pattern that I want to use as a motif with a small variety of voices.

Recording the arpeggiator's MIDI output would help me achieve the same result... if I could figure out how to do that.

Any help from the pros on the forum will be appreciated!

[mcnoone]

There's no arp save feature in Zebra "yet", although it's planned to get one.
I believe you can copy the arp segment from within the H2P file and paste it in your destination H2P file for copying, but I don't know which lines to copy.

[jimstrider]

I believe you can copy the arp segment from within the H2P file and paste it in your destination H2P file for copying...

Excellent! Thank you for this tip.

The lines to copy look like the following -

Agte1=2
Atrp1=0
Avoc1=1
Amul1=1
Amod1=0
AMDpt1=0.00
AMDpB1=0.00
Agte2=2
Atrp2=0
Avoc2=1
Amul2=1
Amod2=1
AMDpt2=0.00
AMDpB2=0.00

The foregoing are the first two sets of 16.

Thanks again!