i try to create a patch wich comes close to this effect unit by g-sonique.
http://www.g-sonique.com/midsidecreativ ... ilter.html
Mid-Side: Creative Stereo-Phase filter+ is a VST effect unit that offers new creative ways of stereophonic sound modulation. It creates special 3D modulation
effects with phasing / filtering and the illusion of effected sound that will fly around your head while the center (mid) of the sound stays untouched. From weird
psychedelic modulation to side phase and filter effects. The possibilities are immense. A very useful and creative effect for producing both electronic dance
and acoustic music for everyone who is looking out for a new, original and progressive/modern sound.
Mid-Side: Creative Stereo-Phase Filter+ works on following principles:
Overall sound is split into mono (MID) and stereo (SIDE) parts of the original signal. You can set a volume amount for the mid and side parts separately, while
the side (stereo) part of the sound can be boosted up to 5 times and be further modulated, which creates new sound possibilities, bigger 3D stereo spacings
and the illusion that the modulated sound is flying around your head.
Stereo (SIDE) part of signal is effected by:
- Phase modulation unit (6 adjustable parameters)
- Time modulation unit with the possibility to delay the side part of the signal against the mid or delay the filtered signal against the side signal, and use a
floating delay modulation of the side signal by a LFO.
- Analog sounding liquid filters (9 types available) and G-Filters, a series modeled after codes from DSP chips of hardware synthesizers and analogue low
pass filters with a creamy sound, again modeled after vintage hardware keyboards/synths which can be modulated by a free-running LFO
(4 waveforms available)
Attention: Mid-Side: Creative stereo-phase filter+ works ONLY with real STEREO signals (This means 2 channels of slightly different signals,
to be real stereo, the signals need to have a minute difference and not just the same one panned left and right) You can detect if your signal is a real stereo
signal by changing the MID scroller to a zero amount, if you hear the SIDE stereo part of the signal, your audio is real stereo. If your channel is mono only you
will not hear any SIDE (stereo) part of signal, but you can make your signal stereo by adding reverb, ping pong delay or other effects.
I came up with this patch below but am not quite sure if im going in the right direction, or if i forgot something to fulfill the basic setup.
It would be great if you could check the patch and if you want edit it to see what we can come up with..
basically i want to make sure that the 1 row is mono and the second row is the side signal without mono..but dont know how to achieve this honestly..
www.suloo.de/Mid_Side%20Filter.h2p
cheers Mark
