Okay so please bare with me because this is hard to explain...
1- I setup multiparameter 1 with two control targets :
Multiparameter 1 (LFO1 value for example with interval mode)
multiparameter 1 parameter 2 (LFO2 Value for example with interval mode)
2- I setup multiparameter 2 to control the Multiparameter 1 value : it works
3- I setup multiparameter 3 to control multiparameter 1 parameter 2 value : it does not work.
Is someone else having this problem ?
Thanks.
MXXX : Multiparameter 2 to control "multiparameter 1 parameter X value" not working ?
-
farfadetfarfelu farfadetfarfelu https://www.kvraudio.com/forum/memberlist.php?mode=viewprofile&u=200417
- KVRist
- 271 posts since 8 Feb, 2009
-
MeldaProduction MeldaProduction https://www.kvraudio.com/forum/memberlist.php?mode=viewprofile&u=176122 - KVRAF
- 14325 posts since 15 Mar, 2008 from Czech republic
I checked and it works. The question is what you mean by "value", because that parameters is range, not actual value!!! Maybe create some screen video of what are you trying to do. Btw. trying to use a multiparameter to adjust another value through other multiparameter doesn't obviously make sense, you can set range for 4 first paramters of each multiparameter and the value of the multiparameter (which results in changing the associated parameters).
-
farfadetfarfelu farfadetfarfelu https://www.kvraudio.com/forum/memberlist.php?mode=viewprofile&u=200417
- KVRist
- Topic Starter
- 271 posts since 8 Feb, 2009
-
MeldaProduction MeldaProduction https://www.kvraudio.com/forum/memberlist.php?mode=viewprofile&u=176122
- KVRAF
- 14325 posts since 15 Mar, 2008 from Czech republic
Aaaaha, it's just not updating in the window - that's a little technically complicated, hard to explain, but the values should actually be changing. Please verify - just close the mutliparam window and open it again, or maybe even selecting the first parameter and back should do the trick.
-
farfadetfarfelu farfadetfarfelu https://www.kvraudio.com/forum/memberlist.php?mode=viewprofile&u=200417
- KVRist
- Topic Starter
- 271 posts since 8 Feb, 2009
You are correct, in fact i have to toggle the multiparameter 1 switch AND select another parameter and back in the multiparameter window to see the change... lolMeldaProduction wrote:Aaaaha, it's just not updating in the window - that's a little technically complicated, hard to explain, but the values should actually be changing. Please verify - just close the mutliparam window and open it again, or maybe even selecting the first parameter and back should do the trick.
It would be cool if the change could be reflected whatever the setting of the switch but it's not that important.
Thanks.
-
MeldaProduction MeldaProduction https://www.kvraudio.com/forum/memberlist.php?mode=viewprofile&u=176122
- KVRAF
- 14325 posts since 15 Mar, 2008 from Czech republic
Yeah, I'll check 