My apologies if the answer to this is well known. The u-he forum is >130 pages now and I haven't been able to locate this with some searching.
My question is: is there a way to positively determine the target of a modulator in the right-hand column? Normally I can just glance through the list of oscillators and spot it, but if there are so many that the left hand column scrolls, or perhaps a modulator is attached to a non-displayed part of the GUI.
I am running 2.6.0 of Z2, incidentally. Thanks kindly.
Zebra question: modulator "where used"
-
- KVRist
- 30 posts since 2 May, 2003 from Southern California
-
- u-he
- 30240 posts since 8 Aug, 2002 from Berlin
-
- KVRist
- Topic Starter
- 30 posts since 2 May, 2003 from Southern California
Thanks kindly for your quick response, Urs.Urs wrote:Not yet. It's been requested though, we're onto it.
And this is why u-he products are not only the best sounding software on the planet but the best supported!
And besides Urs the forum and user community have always been a great resource for me.
:love: