but: As I use Zebra HZ, I find A) I like using the Diva filters, and B) using the Diva filters is painful/clunky. Some if this is down to the way they are treated differently than the "native" Zebra filters.That's fine. The only aspect of this arrangement that is really difficult is the lack of stereo configuration for the filters. I like to use the oscillators in "stereo" mode the majority of the time, and this is where it gets fiddly.
What I end up doing is splitting the signal flow into two lanes, and putting an identical Diva filter on each lane. While not as clean/elegant as a single stereo lane (I can live with that), the real issue is that tweaking any filter settings, mod routings to them, etc now has to be done *twice*, once for each filter. That's the part that's a real creative flow killer. Hard to tell if the cutoff adjustment is correct when you only hear it on one side of the stereo field.
So my request would be that if integrating the Diva filters all the way into Z-HZ is difficult (and I suspect that it probably is), then can we at least have a "pairing" ability so that we can lock a filter to another such that any parameter/modulation changes to one also affect the other? Even if there were just preset pairings (1/2, 3/4...), or "stereo" versions we could choose that used up two... however... I just would rather not have to keep adjusting two knobs back and forth every time I want to just tweak the resonance a little.
Thanks!
