Handy Zebra Trick

[rockmachine]

Hey guys,
When designing and experimenting with sounds in Zebra, I sometimes like going through the scores of wavefiles avavilable to examine how all the different wave sets sound. But one of the problems in doing that, is that you had to then use the mouse to scroll through them all, which I found a real pain. So to make this easier, go to the mod matrix and set the mod wheel as modulator and the wave warp as target with full modulation. Now every wave set you load can be auditioned using the mod wheel. It saves you being stuck with how the original wave set was set up in the oscillator window, which is often set on waveshape number 1 with no modulation. Of course, if it was set up as wave number 8, you will only be scanning from 8>16, but it seems to rarely the case. Hope this helps in you experimenting and desigining sounds.