Andreas - Tape Flanger Buttons?

[sl23]

I was just checking out your tape flanger, finally, great effect btw and I noticed the buttons for turning on or off the modules, but I can't seem to figure out how you did this!!!

Could you shed some light please?

Thanks

Scott

[runaudio]

the auto is a lfo and the manual and on button is a constant modulator which u can find in the modulation generators section in side the mux by right clicking they are pulled over from inside the mux to the front panel and once you do that you just right click on the green button to edit its postion size and looks but make sure you map the on auto and manual to the meta prmtr any one really doesnt matter you can also learn alot from looking inside the other effects see how they have been made

[AndreasD]

As runaudio metioned, the Auto is an LFO and the Manual a Constant Modulator.
To get the green/grey button on the front panel, just drag the modules themselves on the front panel and rename them as required. Then set the Looks to transparent and on switch visible.

And the whole delay network is there twice to have a 1 sample delay on the dry signal to allow the 'through zero' as the wet delay minimum is 1 sample.
With Itchycoo set to zero there in no feedback for the delays, is is should be with normal tape flangeing. Itchycoo just adds (negative = extra peak) delay feedback.

I hope it explains it. (Basically the patch was made after analyzing the Satin flanger)