MuTools

runaudio · Post by **runaudio** » Wed Sep 02, 2015 11:09 pm

hey everyone any help please right when going through my sounds some of my sounds are to loud is there any way that i could have a fader volume set in side mux thanks

MuTools · Post by **MuTools** » Thu Sep 03, 2015 6:21 am

Yes you can add an amplifier or mixer strip to your mux.

runaudio · Post by **runaudio** » Thu Sep 03, 2015 6:44 am

even tryed the mixer strip before you mention it but thanks and when i did it affected the over all sound of the track then

pljones · Post by **pljones** » Thu Sep 03, 2015 5:49 pm

What's inside a MuX only affects what's inside the MuX. If it's affecting other things in the track, your routing is wrong. Can you post a screen shot?

runaudio · Post by **runaudio** » Thu Sep 03, 2015 6:24 pm

nothing just a empty project here

bibz1st · Post by **bibz1st** » Thu Sep 03, 2015 7:04 pm

Are you previewing them in the browser ?

runaudio · Post by **runaudio** » Thu Sep 03, 2015 8:17 pm

yeah i am but when i set the volume low on the mixer strip it also effects the track itself when i add the loop to the arrange window

bibz1st · Post by **bibz1st** » Fri Sep 04, 2015 9:12 am

This is from the docs...

When you insert a module (Rack, MixerStrip, ...) in the Project Modular Area and name it "Preview Monitor" then all previewing will be routed to that module. This way you can control the preview volume and/or add effects to it and/or define to which output it should go.

Does that help ?

runaudio · Post by **runaudio** » Fri Sep 04, 2015 10:41 am

yeah it works like a charm i did have it routed right just had to rename to Preview Monitor thank you very much bibz1st

bibz1st · Post by **bibz1st** » Fri Sep 04, 2015 11:03 am

No worries

MuTools

KVR Audio

previewing sounds