ZEBRA cannot automate LFO rate/amp in reaper ?
-
- KVRist
- 208 posts since 8 Aug, 2010 from London, UK
Fairly sure I was able to do this before, the osc tune and other stuff still automate but when select write and turn the LFO rate knob I get no automation lane for LFO rate or amp, any ideas ?
-
- KVRist
- Topic Starter
- 208 posts since 8 Aug, 2010 from London, UK
Got around it by assigning to XY and automating that but stills seems weird as I can get an automation lane for literally any other knob in the patch just not the only 2 I want to use 
Murphy's law in action,
Murphy's law in action,
-
- KVRist
- 354 posts since 15 Nov, 2005 from Melbourne Australia
No Pretty sure this is standard in all DAW's with Z.
Zebra like many semi-modular or modular synths has a LOT of parameters, and I think somewhere along the line DAW's
started restricting the number of possible Automatable parameters(?)
I usually either automate the XY controller as you mentioned, alternatively I always have a midi controller at hand, and I often just tend to midi learn the LFO rate/amp to a couple of knobs and records midi.
Zebra like many semi-modular or modular synths has a LOT of parameters, and I think somewhere along the line DAW's
started restricting the number of possible Automatable parameters(?)
I usually either automate the XY controller as you mentioned, alternatively I always have a midi controller at hand, and I often just tend to midi learn the LFO rate/amp to a couple of knobs and records midi.