Bug... Envelope Modulator RMS Length Not Updating

[vectorwarrior]

Not sure which other RMS settings or settings in general this affects, but here's how I'm currently reproducing this problem. See if you can repro on your side...

-Open MAutoDynamicEQ
-Add a modulator to anything (e.g. output gain)
-Open modulator screen, set to 'Envelope' with the tab up top
-Lower attack, peak hold and release in 'Detector' to 0ms (just so that you can see the RMS length easier)

Then here's the bug:

-Double click the RMS Length to enter a value, type 0
-Double click the RMS Length to enter a value, type 100
Notice no change in the display below, it should be smoothing the input
-Double click the RMS Length to enter a value, type 100 again
this time you'll see the change.

It seems that RMS changes are not updated until the values are entered twice, or rather, the data entry seems to update to the PREVIOUS entered value, not the one you just typed.

I am also getting similarly odd behavior with the mouse, such as right clicking to set the default to 20ms, it changes when you right click it a second time. So there is definitely something odd with this data entry.

It's not a huge bug, but it may be symptomatic of a larger problem with RMS settings or something else, so i thought i would mention it here.

Thanks!

[MeldaProduction]

Aaaaha, interesting, I'll check it out!