Hi all,
I'm attempting to use Zebra 2 in Cubase 8 Pro on a SP4 using pen and touch, and appear to have hit a snag. After assigning a mod source to a modulation knob I can't find any way to change it.
Normally you would simply right click on it, however Zebra fails to recognise the pen side button or touching and holding for a second, both of which should invoke a right click. I've even set up Toolbar Creator and assigned a button to right click, but that doesn't work either.
Is there any way to access the source menu without a keyboard when the mod knob has already been defined?
Thanks for any help!
(c:
Zebra on Surface Pro 4
-
- KVRist
- 41 posts since 19 Feb, 2005 from Victoria, Australia
-
- KVRist
- Topic Starter
- 41 posts since 19 Feb, 2005 from Victoria, Australia
Other than Toolbar Creator, I'm not sure... I have found a shortcut that simulates right click in Windows (shift + F10), but Zebra doesn't recognise that either.
In the process of trying to get that to work however, I've now discovered if I touch the knob and then roll my finger off it, it usually brings up the menu, strangely enough... so while I can in fact access it now, the method is certainly not ideal.
Edit: Touching and holding the knob with pen or finger and then dragging away from it also works.
In the process of trying to get that to work however, I've now discovered if I touch the knob and then roll my finger off it, it usually brings up the menu, strangely enough... so while I can in fact access it now, the method is certainly not ideal.
Edit: Touching and holding the knob with pen or finger and then dragging away from it also works.