Mux Step Sequencer

[focusrite]

So, how do I play patterns via my piano roll? I've created 2 patterns A & B and read the manual:

Patterns can be selected via MIDI by the lowest notes: Note nr 0 selects pattern 0, note nr 1 selects pattern 1, ... That way you can play patterns on the fly, even multiplex them on the fly, all using the selected sync mode.

I can't get a midi note to change the pattern from A to B. Am I hitting the wrong ones?



=================================================================================
Ok forget that, got it working. I was expecting the lowest held notes to change and play the pattern simultaneously. Lowest notes change the pattern - higher notes play the pattern.

[Taifunk]

Try to playing for example a C4 note and simultaneously use the most low note to select the pattern.
I have attached an 'example

Edit:I realized just now that you've already solved
however, the attached example it may be useful to someone

[focusrite]

Try to playing for example a C4 note and simultaneously use the most low note to select the pattern.
I have attached an 'example

Edit:I realized just now that you've already solved
however, the attached example it may be useful to someone

ha ha thanks anyway

Now then, how to edit pattern B to infinity from the front panel? Possible?

[MuTools]

Why not just open the step sequencer editor then?

[focusrite]

I guess not possible but it would save more button clicks

[runaudio]

check this http://www.kvraudio.com/forum/viewtopic ... 9&t=465527

[focusrite]

Aha, thanks.

[runaudio]

Aha, thanks.

No problem