BR: Clip velocity is sometimes ignored for the first note in the clip

[fromwithin]

Put a single note at the beginning of the MIDI clip and set its velocity to 127.

Move the clip away from the start of the edit.

Set the Velocity on the clip to less than 100%.

Play the clip. That note might be the % velocity you set, but might be 127.

I noticed something weird though...whether it plays at 127 or not is dependent on where the song cursor is when you press play. It is completely deterministic. If you place the cursor at a certain position before pressing play and you get a 127, you will always get a 127 if the cursor starts at that position. If you move it somewhere else and this time get the % velocity, it will once again always play at the % velocity if the cursor start is at that same position.