Tracktion Software

bk · Post by bk » Mon Jun 21, 2004 1:24 pm

Anyone using this successfully? Everytime I add Classic Compresser to an edit, the edit goes silent until I remove it from the edit, then everything is OK again.

I'm pretty sure this used to work. Can anyone confirm?

BK

rpc9943 · Post by **rpc9943** » Mon Jun 21, 2004 1:30 pm

I do believe I have had similar errors

RonC

pdadda · Post by **pdadda** » Mon Jun 21, 2004 3:24 pm

I have no problems using Classic compressor in Tracktion. But I have not updated my version of Tracktion in several months.

midiac · Post by **midiac** » Mon Jun 21, 2004 4:18 pm

BK wrote:Anyone using this successfully? Everytime I add Classic Compresser to an edit, the edit goes silent until I remove it from the edit, then everything is OK again.

I'm pretty sure this used to work. Can anyone confirm?

BK

Hi,

I have Classic Compressor vers. 1.15 and every thing works fine!

Greetings

midiac

bk · Post by bk » Mon Jun 21, 2004 6:46 pm

Thanks all,
Sounds like I've got some troubleshooting to do on this end.

valley · Post by **valley** » Mon Jun 21, 2004 7:15 pm

ISTR classic compressor being one of those vst plugins that can explode in Tracktion[1] if sent too large a signal. I've found a few plugs that seem to go silent when fed a signal they dislike[2]. Probably some math goes out of range, but I don't know why that would be permanent.

[1] dunno if this is a T bug or not, it happens with a few plugins I use, but I've never tested for it in another host.

[2] I had the Tracktion reverb do it once too[3] after sending it a huge and somewhat unexpected resonant peak - one of the pitfalls of 'virtual knobs'.

[3] of course in truth it could just be that I was basically f-cking deafened for about five minutes.

powercenter · Post by **powercenter** » Tue Jun 22, 2004 2:27 am

BK wrote:Anyone using this successfully? Everytime I add Classic Compresser to an edit, the edit goes silent until I remove it from the edit, then everything is OK again.

I'm pretty sure this used to work. Can anyone confirm?

BK

could it be that when you patch the classic into the edit,you then need to turn
on or at least tweak the classic ,this is simple but some times the obivous seems very un -clear

valley · Post by **valley** » Tue Jun 22, 2004 2:55 am

nah, classic compressor ships with a pretty useful default patch.

AD80 · Post by **AD80** » Tue Jun 22, 2004 5:43 am

I have been using Classic Comp since it came out. I use it on every track, and almost every rack filter that has plugs in it. Not a single problem yet. Good luck getting it sorted out.

Njxt · Post by **Njxt** » Tue Jun 22, 2004 8:59 am

Huge fan of the Classic series.
Never had a problem with them and T.

Tracktion Software

KVR Audio

T and Classic Compresser