I am trying to map Collective to my hardware controllers so I can play and automate it more easily - however the automation is all messed up. This screenshot shows the knobs on the main page and what names appear when you try and assign them eg Cutoff is identified as "Drum Reverb", SemiTone as "Bass Delay" etc (this is in Bitwig but the same happens in Kore 2 - I presume this is just what is exposed to the host - looking at the param list they all have names that don't appear to correspond to their functions).
Also in Bitwig 2 (although not Kore) when I try and move more than a couple of these params in fairly quick succession Collective just freezes up the host for several seconds at a time.
Oh and where is the XY pad? It appears in the automatable param list but I can't find it on the GUI or any mention of one in the manual.
Collective automation all mixed up
-
- KVRAF
- 37519 posts since 14 Sep, 2002 from In teh net
You do not have the required permissions to view the files attached to this post.
-
- KVRAF
- Topic Starter
- 37519 posts since 14 Sep, 2002 from In teh net
Also it appears when I do map something the connection is just one way. ie if I move a knob in Collective it moves the mapped knob in Bitwig/Kore, but if I move the controller knob the Collective knob doesn't move correspondingly - although the sound does change.
-
- KVRAF
- Topic Starter
- 37519 posts since 14 Sep, 2002 from In teh net
-
- KVRAF
- Topic Starter
- 37519 posts since 14 Sep, 2002 from In teh net
Hello? This is a mess, please fix it.
-
- KVRAF
- 1790 posts since 30 Dec, 2012
I did pass this on to Wolfram, the Collective dev but he's at Superbooth in Berlin this week so will probably have to wait until next week for a fix I'm afraid.