muting dry DI in tracktion

[MasonAtom]

Tracktion 7 question:

I'm recording some guitar tracks DI using Bias plug-in for amp simulation, and I can't figure out how to mute the dry pre-plug-in track. I have the "live monitor" button enabled and I can hear the sound of the amp sim, but I can also hear the sound of the clean guitar at the same time and it's super annoying.

Anyone know how to mute the clean sound so all I can hear while I'm tracking is the sound of the guitar running through the amp sim? I had figured this out at some point, but then my harddrive died and when I re-installed T7 I can't seem to remember what I did.

Thanks

Mason

[chico.co.uk]

You're probably monitoring on your audio interface too. That'll be the dry signal. Either there'll be a hardware switch, or possibly a tick box in the driver to turn off monitoring through the interface.

[klangbastler]

either what the above or:
does the plugin has a dry/wet control? that needs to be full wet, if it has.

also what do you mean with "the dry pre-plug-in track", do you have more than one track in this setup?