u-he

timyork · Post by **timyork** » Mon Mar 05, 2018 3:42 pm

I'm trying to build a patch in Zebrify that with two separate filters - hi pass and low pass. I want the filters to sweep, and for each filter to autopan, but in the opposite direction to each other. The filters need to work in parallel. I can't figure out how to get two filters working at the same time. If I put them in two separate lanes only one works. Not quite sure how to start with this, if anyone can help..?

Just to re-iterate - the two filters need to be parallel, not running through each other, so each effect is distinctive in it's own right and panning in the opposite direction, or at least sweeping left and right at different times (probably some randomisation is best)..

As in this tutorial for The Drop, between 10m and 14m:

EvilDragon · Post by **EvilDragon** » Mon Mar 05, 2018 3:49 pm

Right-click the filter in second lane and set it to Input 1. Now both filters are parallel. Also add something BEFORE the filter in first lane (like Mix1 module), so that you can tap the signal before it hits that filter.

timyork · Post by **timyork** » Mon Mar 05, 2018 9:33 pm

EvilDragon wrote:Right-click the filter in second lane and set it to Input 1. Now both filters are parallel. Also add something BEFORE the filter in first lane (like Mix1 module), so that you can tap the signal before it hits that filter.

Perfect, thank you!

Howard · Post by **Howard** » Tue Mar 06, 2018 7:53 am

I don't think you need that MIX module. (BTW maybe a single XFM could also do the job - worth investigating!) See attached. BTW I used Input 2 for esthetic reasons.

Droppish Pan.h2p.zip

aaron aardvark · Post by **aaron aardvark** » Sat Mar 10, 2018 5:11 pm

Howard,
Thank you for the patch, I will try it out later.

u-he

KVR Audio

Need help setting up Autopan w two filters in Zebra/Zebrify.