Just illustrating another instance where it would be really nice to be able to modulate the resolution knob in Z2.
Static resolution knob in Zebra 2
-
- KVRAF
- 4197 posts since 23 May, 2004 from Bad Vilbel, Germany
-
- KVRist
- Topic Starter
- 122 posts since 26 Jul, 2016
Because (at least to my knowledge) there is no way to midi learn that knob. It's not automateable/ therefore not selectable via midi. etc.Howard wrote:Why not MIDI-Learn that knob and record MIDI CC instead?
-
- KVRAF
- 4197 posts since 23 May, 2004 from Bad Vilbel, Germany
It is here. Just try it!
(BTW are you sure you're not confusing MIDI CC control with "automation"?)
(BTW are you sure you're not confusing MIDI CC control with "automation"?)
-
- KVRist
- Topic Starter
- 122 posts since 26 Jul, 2016
I've used the internal Midi Table extensively and have always looked at the oscillator destinations/ have never seen the resolution knob. Yet, now, clicking the L (for Midi Learn) and turning the mod wheel, it pops up as if it were in the list.Howard wrote:It is here. Just try it!
(BTW are you sure you're not confusing MIDI CC control with "automation"?)
Now I'm even more confused that it's not a possible destination for scalable modulation.
Last edited by vvilms on Wed Apr 04, 2018 11:35 am, edited 1 time in total.
-
tasmaniandevil tasmaniandevil https://www.kvraudio.com/forum/memberlist.php?mode=viewprofile&u=62450
- KVRAF
- 2171 posts since 22 Mar, 2005 from a planet called u-he
Yep, Howard is right, host automation and MIDI learn are two different things.
While you cannot host automate the osc resolution, you can very well MIDI learn it, and then paint a CC curve in your host to animate the resolution.
While you cannot host automate the osc resolution, you can very well MIDI learn it, and then paint a CC curve in your host to animate the resolution.
That QA guy from planet u-he.