MeldaProduction

mevla · Post by **mevla** » Wed Aug 15, 2018 7:44 am

What is the dead space and the spike ? Shouldn't the release take over immediately after decay when there's no sustain ? And even then, why the spike ?

Patch is 'BP Pad', ADSR modified.

Cheers.

MPowerSynthADSR.jpg

mevla · Post by **mevla** » Wed Aug 15, 2018 7:59 am

OK, got it. Sustain cannot be silence, as shown above. It must be a value. -90 dB does it. But then, there's sustain. So if a note is held, it will not go into release. Is it posssible at all to have a ADR envelope ?

mevla · Post by **mevla** » Wed Aug 15, 2018 10:40 am

Another question. Regarding patch Pad Bright 'Tyro scandalous', can you modify the ADSR release ? Here it's not possible. The value will go up and down, the graph will move, but it will always come back to 625ms, as if it's locked. Same behavior using the Custom Shape. I like this sound - is it possible to 'unlock' the release parameter ?

jmg8 · Post by **jmg8** » Wed Aug 15, 2018 1:45 pm

mevla wrote:Another question. Regarding patch Pad Bright 'Tyro scandalous', can you modify the ADSR release ? Here it's not possible. The value will go up and down, the graph will move, but it will always come back to 625ms, as if it's locked. Same behavior using the Custom Shape. I like this sound - is it possible to 'unlock' the release parameter ?

Just go into Mod1 and remove the ADSR release assignment.

MeldaProduction · Post by **MeldaProduction** » Wed Aug 15, 2018 8:47 pm

Sustain can be silence of course, but in that case this is done to display the release shape and length, without it you would just be blind (though probably all other plugins just leave you blind). Note that the fact that the sustain is silence does NOT mean you cannot release the key before you get to sustain stage

.

MeldaProduction

KVR Audio

MPowerSynth ADSR question