In the recorder, the beat sensitivity slider (lower right, down arrow) appears to be reversed. Higher values cause fewer beats to be detected, lower values cause more beats to be detected.
I would expect the higher value to be more sensitive to beats, thusly causing more beats to be detected. Groove Doctor works this way (as does almost every Beat Sensitivity slider out there).
BR: Beat sensitivity in Multisampler is reversed
-
Robert Randolph Robert Randolph https://www.kvraudio.com/forum/memberlist.php?mode=viewprofile&u=7328 - KVRAF
- 2226 posts since 25 May, 2003 from Saint Petersburg, Florida
-
- KVRian
- 544 posts since 24 Jan, 2004 from Sweden
I suppose the slider sets the trig threshold. So a lower setting will detect weaker beats. Seems logical to me.
-
Robert Randolph Robert Randolph https://www.kvraudio.com/forum/memberlist.php?mode=viewprofile&u=7328
- KVRAF
- Topic Starter
- 2226 posts since 25 May, 2003 from Saint Petersburg, Florida
Sure, if it was called threshold. However it's called sensitivity. Higher = more sensitive = more beats.Stuttaton wrote: Fri Apr 05, 2019 6:42 pm I suppose the slider sets the trig threshold. So a lower setting will detect weaker beats. Seems logical to me.