MDrummer: Route cymbals to separate track as well as OH and Room

[garrettendi]

Hi

Loving MDrummer, I'm getting great results but I've hit one small snag. I route the Ride and the Cymbal 2 to different tracks in Reaper, as well as separate tracks for the OH and Room. I've done the same for other drums as well such as the Kick and Snare. Everything else works fine, but for some reason the Ride and Cymbal 2 were only hitting the OH and Room tracks, even though Cymbal 1 was correctly routing to it's own track. When I change the setting in the Drumset Editor for MultiSampler for OH and Room (I forget what the checkbox was actually called) the cymbals trigger their own tracks but no longer the OH and Room.

I was using the Modern Vintage drumset. I cannot find the relevant place in the Manual, and ideally I'd like all the cymbals in their own tracks and the OH and Room.

Thanks for MDrummer, it's a great plugin!

[goldglob]

DRUMSET EDITOR> LAYER SOURCE> MultiSampler> MIXER.
You'll see that the mics other than OH and Room are set to silence...this is not usual....probably just the way the drumset was last saved in the factory after OH/Room testing. You could just set it up the way you want then save (overwrite) it.
BTW, there's a bug at present with that mixer....if you disable a mic you can't re-enable it.

[garrettendi]

Thanks goldglob! I'll give that a try soon!