Filter or equalize by musical key possible?

[akeia]

Is there a way with Melda EQs or filters to target only frequencies that do belong to a chosen musical key? I want to push or suppress frequencies in the drums that should or should not be there.

I understand that I can manually target these frequencies but the question is if there is some kind of more general solution where I generally can boost or cut frequencies of a given musical key in audio?

[jmg8]

You could use a multiparameter to do this.
Set the MP to banks mode and start inputting the correct frequencies into each bank slot (this will be easy as there is a little pop-up keyboard when double-clicking a frequency parameter)
Make sure to turn off interpolation of the banks.
Now when you use this MP to sweep through the frequency, it will snap to scale.

[ericzang]

Another way that might be helpful would be to control the eq freq via midi note:


(Hi jmg!)

[akeia]

Thanks guys. This are very good suggestions. I was able to work something out using the midi note mechanism.