with multibandconvolution possible to change mix rate of A/B IR unit depend on RMS level of input ?

[magicmusic]

Each band have 2 IR units that can mix with a Mix slider. to simulate speaker cabint which have diffrent impulse responses depend on the volume of the signal maybe it can simulate that it sound not so static when it is possible to change the mix of A/B depend on the level of input signal(which occur in this band)

I wish not perfect simulate a cabinet i only wish to simulate that it sound not so static as current cabinet emulations. maybe with dynamic mix rate of 2 IR there can create better sound cabinets as real cabinets.

[jmg8]

You can modulate the A/B ratio with a follower. Will that work for you?

[magicmusic]

thanks i read what follower can do and it is what i need. it seem work without side chain it allow a RMS time to set and look very powerfull.