Thanks to Chandler's video I can use MSuperLooper so far w/o crashing. The crash might have to do with not setting the sync option before recording. Eg. Load MSuperLooper on a synth track and immediately press its record button, then press the DAW transport button. Play a few notes, crash.
So I can get it to run seemingly good if I follow Chandler's way. Set the sync option then specify the number of bars, then start the DAW transport and press the MSL's record button a bit later.
Question. As can be seen here MSL stopped at one point and the DAW (Bitwig) was reset to 0. When the DAW starts at zero, MSL will start from its current position. Is there a way, as in MCCGenerator, to sync the start point to the DAW's starting point ?
MSuperLooper: sync start ?
-
- KVRAF
- 3729 posts since 3 Nov, 2015
You do not have the required permissions to view the files attached to this post.
-
- KVRAF
- Topic Starter
- 3729 posts since 3 Nov, 2015
In any case I tried it again. Doing the same thing as on the video, it crashed during the recording of an 8-bar pattern. The one and only Melda plugin that crashes. Hopefully there is no 'new' technology in this plugin that will be spread to other plugins later on, on the basis of improvement .
For the time being, I'll just let it go and will come back to it in a few months or so.
For the time being, I'll just let it go and will come back to it in a few months or so.
-
MeldaProduction MeldaProduction https://www.kvraudio.com/forum/memberlist.php?mode=viewprofile&u=176122 - KVRAF
- 14339 posts since 15 Mar, 2008 from Czech republic
I'm afraid I don;'t really understand the question - what kind of way is there in MCCGenerator to "sync the start point to the DAW's starting point"?
Anyways there are some bugs in this indeed. Working on it!
Anyways there are some bugs in this indeed. Working on it!
