Bug Report: Chord Companion - custom chords, octave issues

[GoRhino]

I have some custom chords set-up for use with the Pattern Generator. Handily, these show up at the bottom of the list of chords potentially available in the Chord Companion. If you click on the appropriate "lit" circle you audition that chord in the selected key and see the notes on the keyboard - just like the pre-set chords. Great so far!

However, if I drag a custom chord across to a pad although the name correctly displays on the pad, only a single very low (couple of octaves below) note is played and shown - very disappointing and limits the usefulness of this nifty plug-in.

Also, with the pre-set chords, when dragged to the pads they seem to default to an octave above the audition position. True you can use "numbers" to shift down again, but shouldn't the default be at "0" to give the greatest flexibility?

Another slightly annoying feature is that although I have made appropriate setting changes to line-up my pads (Maschine Mikro Mk3) so that the note numbers (well octaves at least) align with W11 generally. In Chord Companion the notes are all over the place, ie my C1 (note 12) reports same in MIDI Monitor, but is C0 on the pad in CC, and C-1 on the keyboard in CC. What is going on here?