Feature Request: Novation Remote 25 USB Support

[SoftJunkie]

Ability to control Receptor using the Novation Remote 25, Remote 25 Audio and X-Station over USB.

I would imagine that these use the same USB protocol since they are essentially the same keyboard.

[Rick@MuseResearch]

The following USB keyboards have been tested and are known to work with Receptor's USB port:

M-Audio Oxygen 8
M-Audio Radium 49
The following USB keyboards have been tested and do not work with Receptor's USB port:

Novation ReMOTE-25

Ability to control Receptor using the Novation Remote 25, Remote 25 Audio and X-Station over USB.

I would imagine that these use the same USB protocol since they are essentially the same keyboard.

[SoftJunkie]

Understood. I am requesting that Novation Remote be supported in a future release.

[SoftJunkie]

with the 1.2 release adding keyboard zone support, a usb controller with a receptor and a set of headphones would make a great little setup since some of these devices are usb-powered.

The following USB keyboards have been tested and are known to work with Receptor's USB port:

M-Audio Oxygen 8
M-Audio Radium 49

has anyone tried the other m-audio keyboards with the receptor's usb port?

Keystation 49e (49-Key USB MIDI Controller)
Keystation 61es (61-Key Semi-Weighted USB MIDI Controller)
Keystation 88es (88-Key Semi-Weighted USB MIDI Controller)
Keystation Pro 88 (88-Key Hammer-Action USB Bus-Powered Master MIDI Controller)
M-Audio O2 (Ultra-Compact Mobile USB MIDI Controller)
M-Audio Ozone (USB Audio/MIDI Mobile Workstation)
Radium49 (49-Key USB MIDI Controller)
Radium61 (61-Key USB MIDI Controller)

[DanTimis]

has anyone tried the other m-audio keyboards with the receptor's usb port?

Keystation Pro 88 (88-Key Hammer-Action USB Bus-Powered Master MIDI Controller)

The Keystation Pro 88 works. We actually had one at NAMM and it was using USB. I also have one at home.

I noticed that if I turn on my powered speakers after Receptor and the keystation are powered it may stop working and I have to reboot the Receptor and turn the Keystation off and on. The power is not grounded where I have this setup (I'll have to fix this) so this may be one of the problems. Now I always turned the speakers first and it has worked flawlessly since.