making loops follow project key
-
- KVRist
- 385 posts since 7 May, 2009
can loops folow the project key like logic pro x?i would love to drag a loop in and waveform convert it to the key ive set in waveform
-
- KVRAF
- 4891 posts since 3 Jan, 2003 from Vancouver
Select the loop clip in your edit, open up the Control Panel into "actually useful" mode, select the Loop Properties tab and fiddle with the settings.
A lot depends on whether or not your loop already has its root not set, whether or not you have chords in the chords track, etc...
1. Confirm or set the Root Note
2. Turn on Auto-Pitch
3. Set the Auto-Pitch Mode
That should be a good start. I'm not so sure about how well it works when set to the key mode. I think that just sets it to the root key. I doubt it will follow chord changes. I've never used Logic, so I can't compare.
A lot depends on whether or not your loop already has its root not set, whether or not you have chords in the chords track, etc...
1. Confirm or set the Root Note
2. Turn on Auto-Pitch
3. Set the Auto-Pitch Mode
That should be a good start. I'm not so sure about how well it works when set to the key mode. I think that just sets it to the root key. I doubt it will follow chord changes. I've never used Logic, so I can't compare.
You do not have the required permissions to view the files attached to this post.
Surely there must be consensus by now...
-
- KVRist
- Topic Starter
- 385 posts since 7 May, 2009
thank you. logic is really easy,you set a project key, then drag in a loop and that loop matches the project.