Feature Request: Menu option to replace a module in Zebra 2 & 3

[dorremifasol]

Greetings
I was not sure in what thread to post this and if it's been mentioned before. Excuse me if it's been already addressed.
I'm the proud owner of a Nord Modular G2, and one of the things I love the most of it is the software editor. To me there isn't any other modular editor that comes close to it's immediacy and ease of use.

One of the features I like the most is the ability to replace one module with another. One just has to click on a small arrow in a module to replace it with a different one from the same category, and the common parameter values (ie. cutoff, res, etc) will be automatically copied to the new module. This saves a lot of time when trying different modules to achieve different results.

I wish Zebra 2 had some of this capability, as I really dislike the idea of having to remove a module before placing a new one in the same position. I think the best way to add this functionality could be adding a sub-menu to the existing menu to replace the current module with another.

I've made a mockup of how it could look. Maybe the option could be shown on top to prevent the menu from being too high.

Cheers!

zebra 2 replace.png

[alberto_balsalm]

Would also be nice to be able load OSC waveforms without any other changes, because as is, loading an OSC preset completely overwrites all the parameters. Very inconvenient at times.

[Howard]

Alberto: Wavesets can be copy/pasted. Right-click in the waveform editor window.