Hi, I would like to ask you, how can I write this piece of sheet music on the Step Sequencer?
There is a triplet in there and I don't know how to program it.
The triplet in the Step Sequencer
-
Zasdg
- KVRist
- Topic Starter
- 76 posts since 6 Sep, 2016
You do not have the required permissions to view the files attached to this post.
-
Zasdg
- KVRist
- Topic Starter
- 76 posts since 6 Sep, 2016
May be Note Lane Setup - Time Offset?
-
pljones - KVRAF
- 6902 posts since 8 Feb, 2003 from London, UK
That dotted quaver plus semiquaver is tricky... If you want to be totally accurate, you'd need 48 steps, I think (4 beats at 12 steps per beat, allowing division into groups of 3 for semiquavers and four for quaver triplets). You might find it easier using a sequence (which you can set to 1/48th) and triggering that once every bar.
(Oops, cut off the G)
You do not have the required permissions to view the files attached to this post.
-
Zasdg
- KVRist
- Topic Starter
- 76 posts since 6 Sep, 2016
Thank you
-
Michael L - KVRAF
- 4025 posts since 25 Jan, 2014 from The End of The World as We Knowit
What if you could drop a midi loop on the step sequencer and have the relevant MIDI file data automatically mapped to the step sequencer parameters?
You could then easily transpose that sequence depending on the note input, and modulate it, etc using the sequencer parameters.
Would you find that very useful?
You could then easily transpose that sequence depending on the note input, and modulate it, etc using the sequencer parameters.
Would you find that very useful?
don't
want
more
want
more
