Controlling vst parameters

[gentleclockdivider]

I am building a controller for the gforce sem , as all vst parameters these are in the rang 0-1.
but I 'mhaving difficulties wih the the attack and decay stages
On the vst , the attack decay knob are expoential a the start but tis is verry hard to realise with architect .
I am using an interval value of 0.0001 ans still while holding shift ( for fine tuning ) it's not exactly what I want it to be
Outlined in red , yo see the coresponding value on both sem and architect

[gentleclockdivider]

using a simple multiply module (multilpying knob range with itself ) gets it close enough

[colin@loomer]

Doesn't quite help you at this exact moment in time, but the next release has skewing on the UI controls allowing you to get exponential curves for parameters. It's useful for things like delays, where you want accuracy at low times and range at higher values.

[gentleclockdivider]

All good , the output of the parameter cubed ( range 0-1) for envelope and attack works perfectly !