Hi all.
I'm new to Zebra 2 and getting familiar with the arpeggiator. I'm not finding any velocity control for individual steps — is that accurate, or am I missing something?
Velocity in Arp?
-
- KVRian
- 814 posts since 18 May, 2007 from Berlin
Hi 73keyz,
that's right, it takes the velocity values of the MIDI notes it receives. Alternatively you could modulate a volume parameter of your choice via the extra mod values that you can set per step. In the sequencer tab, top left corner of that tab, you see SEQ highlighted, with +A and +AB next to it, these are buttons that will make the mod values visible. +A gives you one mod value per step, +AB gives you two. These correspond to "ArpMod" and "ArpMd2" that you can select in any mod source slot throughout the synth, or in the mod matrix.
Hope that helps!
Viktor
that's right, it takes the velocity values of the MIDI notes it receives. Alternatively you could modulate a volume parameter of your choice via the extra mod values that you can set per step. In the sequencer tab, top left corner of that tab, you see SEQ highlighted, with +A and +AB next to it, these are buttons that will make the mod values visible. +A gives you one mod value per step, +AB gives you two. These correspond to "ArpMod" and "ArpMd2" that you can select in any mod source slot throughout the synth, or in the mod matrix.
Hope that helps!
Viktor