When voice mix volume is set to zero ( as shown in first sscreenshot )there is no modulation happening at all .
Raising the voice mix volume value still doesn't give a full opening-closing vca
MSEG to vca 1
-
gentleclockdivider gentleclockdivider https://www.kvraudio.com/forum/memberlist.php?mode=viewprofile&u=203660 - Banned
- 6787 posts since 22 Mar, 2009 from gent
I want the mseg1 to control the first vca , which is set to gate but results are not as expected
When voice mix volume is set to zero ( as shown in first sscreenshot )there is no modulation happening at all .
Raising the voice mix volume value still doesn't give a full opening-closing vca
When voice mix volume is set to zero ( as shown in first sscreenshot )there is no modulation happening at all .
Raising the voice mix volume value still doesn't give a full opening-closing vca
Eyeball exchanging
Soul calibrating ..frequencies
Soul calibrating ..frequencies
-
- KVRAF
- 2061 posts since 8 Feb, 2013 from Switzerland
u-he Zebra 2 Manual:
"VOL / MOD
Lane volume knob and assignable modulation knob. Modulation here scales the volume from 0% through 100% (center) to 200%. ...
Note: If you want a unipolar modulation source to fade a lane in from zero it’s best to use the modulation matrix instead. "
"VOL / MOD
Lane volume knob and assignable modulation knob. Modulation here scales the volume from 0% through 100% (center) to 200%. ...
Note: If you want a unipolar modulation source to fade a lane in from zero it’s best to use the modulation matrix instead. "
-
- KVRAF
- 4197 posts since 23 May, 2004 from Bad Vilbel, Germany
Alternatively you can invert that MSEG, turn up the lane volume and modulate it negatively 